Harmonic ProView 7000 Quick Setup Manual page 10

iv Click
The displayed properties are divided into two sections; the section on the left
displays editable properties and the section on the right provides informative/status
properties that cannot be edited by the EMS user.
v Configure the properties in the left section and click
2. To map a multiplex in port to a CAM Slot:
i Select the required CAM Slot name in the Physical Input box.
ii Click
The dialog displays with the programs descrambled by the slot.
iii Select a multiplex in port to connect to the CAM slot.
© 2010 Harmonic Inc.
How to Configure and Monitor the ProView 7000
in the bottom left corner of the properties dialog.
Show Status
on the EMS toolbar.
Properties
Apply
10
.
ProView 7000, v.2.3, Rev. A