Operator Qualified For Normal Machine Use; Joperating; Start Up; Set A Program - Electrolux SPEEDELIGHT Installation And Operating Manual

• receive adequate training and instruction for their duties in
order to perform them safely;
• receive specific training for correct machine use.
I.3 Operator qualified for normal machine
use
Must have at least:
• knowledge of the technology and specific experience in
operating the machine;
• adequate general basic education and technical knowledge
for reading and understanding the contents of the manual,
including correct interpretation of the drawings, signs and
pictograms;
J OPERATING
J.1

Start up

WARNING
Refer to "Safety Information".
Press the ON/OFF button to switch on the appliance.
The display shows first the "Welcome" screen, the lid opens
automatically and then the preheating starts.
( Welcome )
During this time, up to 20 minutes, it is not possible to carry out
any action.
At the end of the preheating mode the display will show all the
programs available and the appliance is now ready to use.
J.2

Set a program

• To start the required program, close the lid and press the
corresponding program button.
22
• sufficient technical knowledge for safely performing his
duties as specified in the manual;
• knowledge of the regulations on work hygiene and safety.
In case of a significant anomaly (e. g. short circuits, wires
coming out of the terminal block, motor breakdowns, worn
electrical cable sheathing, etc.) the operator for normal
machine use must:
• immediately deactivate the machine.
• immediately deactivate the machine and disconnect all the
supplies (electricity, gas, water).
• immediately deactivate the machine by turning the switch
disconnector to "O" or operating the main emergency switch
on the equipment;
• close the machine water supply by shutting off the water.
IMPORTANT
According to your model, the keyboard may be
different. In this case, consider that the "3/4" button
corresponds to number" 3" and "S" button corre-
sponds to number "4" while setting the programs.
NOTE!
The symbol "-" means that the program was
deleted.
To set up a program enter a cycle duration.
To delete a program, reset the cycle duration.
• When the cycle starts, the display shows the following
information:
A. Program number
B. Program timer/countdown
C. Microwave phase running
D. Program STOP option ( to be carried on by pressing the
buttons "7" or "8" within 9 seconds).
NOTE!
If you open the lid before the end of the program,
the display shows the icon
signal sounds for 5 seconds. When the acoustic
signal stops, the icon
of the display.
To remove this icon press simultaneously the
buttons "7" and "8" for 4 seconds. When the
password menu activates enter the required pass-
word. The icon disappears.
and an acoustic
remains visible, at bottom