Weigher - Fancom 743 Installer Manual

Fancom 743

5.3.4 Weigher

>>Weigher
3×
Weigher content
Valve status
Motor control
Weigher type WHOP-RIN
Weigher tare
Capacity
Address ILM
Counts
Zero/offset
Span
Filter
Stable
Hopper
Max.sensor
Min.sensor
Empty hopper
Mixer relay
Status
Wait time dec.
Min.dec./30sec
Empty weigher
Block during Tr
Simulation
Increase
Decrease
Status
Weigher
The current weigher content (accurate to the gram).
content
Valve status
The current unloading valve status under the weighing hopper: OPEN or
CLOSE.
Motor control
Enter the time (accurate to tenths of seconds) needed by the motor to fully open
or close the unloading valve. This time depends on the type of weigher
(weighing drum ~ 4 sec.; steel weighing hopper ~ 0.8 sec.).
Weigher type
Enter the type of weigher:
WHOP-MOT
WGDRUM
WHOP-RIN
OUT-AUG
Weigher tare
The weight (accurate to the gram) of the empty weigher.
Capacity
Enter the portion size (kg).
Address ILM
Enter the ILM module address (0-31). The value 0 means that the load-cells are
connected directly.
0. 0
CLOSE
0.0
0.000
0.0
0
0
0
0
0
0.000
NO
0. 0
0. 0
0:00
0. 0
OFF
0:00
0.000
0:00
NO
NO
0.000
0.000
DECREASE
Standing steel weigher with a valve motor controlled in one
direction (motor control).
Polyester, hanging weigher with a valve motor controlled in two
directions.
Standing steel weigher with a valve controlled by a solenoid
(rinse control).
Dosing out auger direct from the weigher
10
INSTALLER: 5. System settings