Important Notices To The Installer - Inter-fab EDGE ANSI/NSPI-5 Assembly/Installation Instructions

I N S T A L L A T I O N M A N U A L E D G E ™ D I V I N G S Y S T E M
IMPORTANT NOTICES
TO THE INSTALLER
The specifications found on page 5 of this manual represent the minimum water envelope
required by Inter-Fab and by the ANSI/NSPI-5 2003 Standard for residential Inground Swimming
Pools. Each of these dimensions must be met or exceeded. Installation of a diving board of any
type on a pool that does not meet or exceed each of the minimum specifications as provided on
page 5 including but not limited to the slope requirement, is in direct violation of this manufacturer's
instructions and the 2003 Standard, and can result in serious injury or death.
Installation of this Edge Fiberglass Stand and Edge Diving Board is limited to Residential Inground
Pools ONLY.
There is only one Edge Fiberglass Stand and only one Edge Composite Spring Set. You can install
either a 6' or 8' Edge diving board on this assembly in accordance with Table 1- Minimum Water
Envelope ANSI/NSPI-5 2003 and Table 2- Inter-fab Residential Pool Minimum Specifications on
page 5. Installing any diving board greater than 8' on any Edge Stand is strictly prohibited.
Inter-Fab Edge Diving Boards are designed for use only with the Edge Diving Stand and Edge
Composite Spring Set. Edge components are only compatible with other Edge components.
Comply with local government regulations for Residential Inground Swimming Pools if they exceed
the ANSI/NSPI-5 2003 Standard for Residential Inground Swimming Pools.
DO NOT USE ANY EDGE DIVING COMPONENTS WITH NON-EDGE COMPONENTS!
Read carefully pages 10–15 of this installation manual which contain portions of the ANSI/NSPI-5
2003 Standard for Residential Inground Swimming Pools, ensure that you understand the minimum
required diving water envelope in Figure 3 and Table 1 provided in the ANSI/NSPI-5 2003 Standard.
NOTE: The installation of this Edge Diving Stand/Edge Diving Board is not complete until you, the
installer have measured the pool as well as the diving board's overhang, height above water and
the fulcrum distance to ensure they meet the Inter-Fab's Residential Pool Minimum Specifications
and the ANSI/NSPI-5 2003 Standard for Residential Inground Swimming Pools. In addition; the
installation of this commercial diving board is not complete until you the installer have delivered to
your customer and reviewed with your customer the "Owners Manual" as well as the "Plan Your
Dive Steer-Up" brochure.
THE EDGE DIVING SYSTEM IS A JUMP BOARD
ONLY ONE PERSON AT A TIME ON THE DIVING BOARD,
WITH A MAXIMUM WEIGHT LIMIT OF 300 LBS.
EDGE-IM Rev. 6/08 (BBK-EDGE INSTAL) 4