FujiFilm WP-FXA500 Owner's Manual page 39

4
Open the waterproof case carefully and take the camera out of
it.
5
After making sure that there are no water droplets or foreign
particles on the waterproof sealing, close the waterproof case
and seal it tight. Wash it thoroughly with fresh water once
again.
6
After wipe off the water droplets from waterproof case and open
the waterproof case a little and dry it in a breezy place out of
direct sunlight. After drying the case, store it where it will not be
directly exposed to sunlight.
Before opening the waterproof case,
confirm that your hands and hair are
dry and will not drip onto the camera
and the inside of the waterproof
case.
Open the waterproof case with the
lens facing downwards to avoid the
camera falling out.
When your hands are wet, make
sure not to touch the camera or the
battery.
Do not open the waterproof case in
places where the inside might get
wet or sandy.
Try to remove any remaining salt by
lightly moving the various buttons
under the water.
We recommend soaking it in fresh
water for about 1 hour.
If stored with drops of salty water
on it, salt crystals will clog the
movement of the buckle and other
parts. Rusting may also be caused.
Do not use a hair dryer, warm or
hot air, or direct sunlight to dry the
waterproof case.
EN-15