Control For Hdmi - Sony STR-DA5600ES Operating Instructions Manual

• Make sure you set the tuning interval
correctly (when tuning in AM stations
with direct tuning).
• No stations have been preset or the preset
stations have been cleared (when tuning by
scanning preset stations). Preset the
stations (page 66).
• Press DISPLAY so that the frequency
appears on the display.
The system cannot receive satellite
channels at all.
• The receiving condition is not good. Move
the antenna to the place where the
condition is good.
• Check that you subscribed to the desired
satellite radio service (page 67).
RDS does not work.
• Make sure that you are tuned to an FM
RDS station.
• Select a stronger FM station.
The RDS information that you want
does not appear.
• Contact the radio station and find out
whether or not they actually provide the
service in question. If so, the service may
be temporarily out of order.

Control for HDMI

The Control for HDMI function does not
work.
• Check the HDMI connection (page 26).
• Make sure "Control for HDMI" is set to
"ON" in HDMI settings menu.
• Make sure the connected component is
compatible with the Control for HDMI
function.
• Check the Control for HDMI settings on
the connected component. Refer to the
operating instructions of the connected
component.
• If you change the HDMI connection,
connect/disconnect the AC power cord, or
there is a power failure, repeat the
166
GB
procedures of "Preparing for the
"BRAVIA" Sync" (page 102).
• If you select "HDMI A" or "HDMI
A + B," after you have selected "HDMI B"
or "OFF," the Control for HDMI function
may not work properly for a while. This is
because the component connected to the
HDMI OUT A jack must re-recognize the
receiver that is equipped with the Control
for HDMI function. If the Control for
HDMI function does not work properly for
a long time, perform the steps given in
"Preparing for the "BRAVIA" Sync"
(page 102).
• When you select "HDMI B" or "OFF," the
Control for HDMI function does not work
properly.
• When "Control for HDMI" is set to
"OFF," the "BRAVIA" Sync does not
work properly, even if a component is
connected to the HDMI IN jack.
• The types and the number of components
which can be controlled by the "BRAVIA"
Sync are restricted in the HDMI CEC
standard as follows.
– Recording component (Blu-ray Disc
recorder, DVD recorder, etc.): up to 3
components
– Playback component (Blu-ray Disc
Player, DVD player, etc.): up to 3
components
– Tuner-related component: up to 4
components
– AV receiver (audio system): up to 1
component
No sound is output from the receiver
and TV speaker while using the System
Audio Control function.
• Make sure the TV is compatible with the
System Audio Control function.
• If the TV does not have System Audio
Control function, set the "Audio Out"
settings in HDMI settings menu to
– "TV+AMP" if you want to listen to the
sound from the TV speaker and
receiver.