Switching The Monitors That Output The Hdmi Video Signals - Sony STR-DA5600ES Operating Instructions Manual

Switching the monitors
that output the HDMI
video signals
When you have two monitors connected to the
HDMI OUT A and HDMI OUT B jacks, you
can switch the output for these two monitors
using the HDMI OUTPUT button on the
multifunction remote. This operation cannot
be performed using the simple remote.
HDMI
OUTPUT
1
Turn on the receiver and the
two monitors.
2
Press HDMI OUTPUT.
Each time you press the button, the output
will be switched as follows:
HDMI A t HDMI B t HDMI A + B
t OFF t HDMI A...
You can also use the HDMI OUT button
on the receiver.
Notes
• If the compatible video format differs between the
monitors connected to the HDMI OUT A jack and
the HDMI OUT B jack of the receiver, "HDMI
A + B" may not work.
• Depending on the playback component you
connect, "HDMI A + B" may not work.
Outputting the HDMI
signals even when the
receiver is in standby
mode
(Pass Through)
You can output the video and audio signals
from the HDMI IN jack to the TV connected to
the HDMI OUT A jack even when the receiver
is in standby mode.
When you activate this function, make the
settings for "Pass Through" following the
?/1
steps below.
1
Select "
menu, then press
2
Select "HDMI," then press
or b.
3
Select "Pass Through," then
press
4
Select the parameter you want,
then press
Parameter
ON
V/v/b,
MENU
Settings" from the
or b.
or b.
or b.
Explanation
When the receiver is in the
standby mode, the receiver
continuously outputs HDMI
signals from the receiver's
HDMI OUT A jack.
continued
105 GB