Setting Remote Commander Codes That Are Not Stored In The Remote - Sony STR-DA5600ES Operating Instructions Manual

Tip
If the RM SET UP button flashes five times in step
1, and the macro programming process does not
start, replace the batteries with new ones.
To cancel programming
Not pressing any button for 60 seconds cancels
the settings.
The previous command remains valid.
Starting macro play
1
Press AMP.
The AMP button lights up, and then turns
off.
2
Press MACRO 1 or MACRO 2 to
start the macro.
The macro starts and execute the
commands in the order you assigned
them. While the commands are being
sent, the AMP button flashes and the RM
SET UP button lights up. When the
commands have been sent, the RM SET
UP and AMP buttons turn off.
To erase a programmed macro
1
Press MACRO 1 or MACRO 2 for more
than 1 second while pressing RM SET
UP to clear the stored macro.
The RM SET UP button flashes.
2
Press RM SET UP.
Settings stored as macro are cleared.
158
GB
Setting remote
commander codes that
are not stored in the
remote
Even if a remote commander code is not one of
the presets stored in the remote, it is possible
for the remote to learn the code using the
learning function.
Note
When setting up the receiver to learn the remote
command modes, replace the batteries with new
ones.
THEATER
SHIFT
Input
buttons
* To store a new command on one of those buttons,
press SHIFT beforehand.
RM SET
UP
?/1
TV
Buttons
used to
learn
code*
Buttons
used to
learn
code