Chapter 3 - Configuration Of Tr80; Introduction; Entering The Configuration Mode - Honeywell TR80UWD Installation And Operating Manual

CHAPTER CHAPTER
3 3

3.1 INTRODUCTION

This chapter provides descriptions for all Modbus registers and configuration parameters that
can be used to adopt the TR80 to specific requirements.
The information is provided in tables, showing:
• Modbus register type (Coil / Input / Holding)
• Modbus register address in two schemes (decimal and absolute)
• Modbus register direction (R = Read Only; R/W = Read/Write)
• Unit and scaling for modbus read/writes where necessary
• Configuration parameter number, if it is a parameter that appears on the device config menu.
• Factory default value.
• Most registers and configuration parameters are self-explanatory, but further explanations
are provided for most.

3. 1. 1 Entering the configuration mode

Only installer or authorized service engineer can access this mode. The procedure to configure
parameter is as follows:
1. Long press and
The setting icon is displayed on the screen.
2. Enter the Pin. Refer
Note: Default pin is 4663. Change the defult pin on completion of commissioning. Refere
control and timeouts
3. Tap
Parameter Number keep blinking at the top part of the display and the parameter's value on
the bottom part.
TR80 - Installation and Operation Guide
CONFIGURATION OF TR80
together to enter in configuration mode.
Entering The Pin
to change pin
to change selected parameter.
section for more details.
User access
32