Connecting A Pre-Main Amplifier (Zone 3) - Onkyo TX-RZ740 Instruction Manual

Connecting a Pre-main Amplifier (ZONE 3)

a
BD/DVD
a Analog audio cable
Contents Connections
≫
You can enjoy 2-ch audio in the separate room (ZONE 3) while performing
playback in the main room (where this unit is located). Use an analog cable to
connect the ZONE 3 PRE/LINE OUT jack of this unit and the LINE IN jack of the
pre-main amplifier or power amplifier in the separate room. The same source
can be played back in the main room and ZONE 3 simultaneously. Also, different
sources can be played back in both rooms.
• To output audio from an externally connected AV component to ZONE 3, use
an analog audio cable for connection. Note that ZONE 3 output is not possible
with the connection using a HDMI cable, digital coaxial cable, or digital optical
cable.
Setup
• This function can be used when any of the combinations among 2.1 ch, 3.1
ch, 4.1 ch, 5.1 ch, 2.1.2 ch*, 3.1.2 ch*, 4.1.2 ch* and 5.1.2 ch* in "Speaker
combinations"(
Note this function cannot be used if Bi-AMP or ZONE 2 (ZONE SPEAKER) is
a
used in speaker combinations with "*" mark.
(For North American models only) Note that if a power amplifier is connected
to the ZONE 3 PRE/LINE OUT jacks, ZONE 2 (ZONE SPEAKER) and ZONE
3 (ZONE SPEAKER) can be used.
LINE
• When connecting the power amplifier, set "6. Multi Zone" - "Zone 3" - "Output
IN
Level" (
volume is output and the power amplifier, speakers, etc. may be damaged.
Premain Amp.
79
Playback
≫
p67) is used.
p174) to "Variable" on the Setup menu. If it is not set, a large
Front Panel≫ Rear Panel≫ Remote≫
Setup
≫ ≫