Connecting An Av Component In A Separate Room (Multi-Zone Connection); Connecting A Pre-Main Amplifier (Zone 2) - Onkyo TX-NR686 Instruction Manual

Connecting an AV Component in a Separate Room (Multi-zone Connection)

Connecting a Pre-main Amplifier (ZONE 2)

a
BD/DVD
a Analog audio cable, b Digital coaxial cable
Contents
b a
OR
LINE
IN
Premain Amp.
Connections
≫
You can enjoy 2-ch audio in the separate room (ZONE 2) while performing 7.1-
ch playback in the main room (where this unit is located). Use an analog cable
to connect the ZONE 2 LINE OUT jack of this unit and the LINE IN jack of the
pre-main amplifier in the separate room. The same source can be played back in
the main room and ZONE 2 simultaneously. Also, different sources can be played
back in both rooms.
• To output audio from an externally connected AV component to ZONE 2, use
either a digital coaxial cable, digital optical cable or analog audio cable for
connection. Also, the audio from externally connected AV components can be
output to ZONE 2 only when the audio is analog or 2ch PCM signal. When
the AV component is connected to this unit with a digital coaxial cable or
digital optical cable, change the audio output of the AV component to the PCM
output.
37
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫ ≫