Onkyo TX-RZ740 Instruction Manual page 59

„ 5.1.2 Channel System (Bi-Amping the Speakers)
8 7
3
2 1
6
5 4
This is a combination of the 5.1 Channel System and front high speakers. A front high speaker is a type of height speaker.
You can select only one set of height speakers from the following three types for connection.
❏ Front High Speakers/Rear High Speakers Installation Example (
❏ Ceiling Speakers Installation Example (
❏ Dolby Enabled Speakers (Dolby Speakers) Installation Example (
You can configure a 5.1.2 Channel System by connecting front speakers that support Bi-Amping connection. The Bi-
Amping connection can improve the quality of the low and high pitched ranges. Be sure to remove the jumper bar
connecting between the woofer jacks and tweeter jacks of the Bi-Amping supported speakers. Refer to the instruction
manual of your speakers as well.
Contents
For high- For high-
frequency frequency
For low-
frequency
p22)
p23)
p24)
Connections
≫
59
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
"Speaker Setup" settings during
„
Initial Setup ( p181)
Speaker Setup
Speaker Channels 5.1.2 ch < >
Subwoofer Yes
Height 1 Speaker ---
Height 2 Speaker Front High
Zone Speaker No
Zone 2 Preout Zone 2
Bi-Amp Yes
Speaker Impedance 6ohms or above
Select how many speakers you have.
• Speaker Channels: 5.1.2 ch
• Subwoofer: Yes
• Height 1 Speaker: ---
• Height 2 Speaker: Select the
type of height speaker actually
installed.
• Zone Speaker: No
• Zone 2 Preout: Set any value
( p158)
• Bi-Amp: Yes
• Speaker Impedance: Set any
value ( p46)
≫
Next