Connecting; Before Connecting - Panasonic PT-RZ21К Operating Instructions Manual

Connecting

Before connecting

f Before connecting, carefully read the operating instructions for the external device to be connected.
f Turn off the power of all devices before connecting cables.
f Take note of the following points before connecting the cables. Failure to do so may result in malfunctions.
g When connecting a cable to a device connected to the projector or the projector itself, touch any nearby
metallic objects to eliminate static electricity from your body before performing work.
g Do not use unnecessarily long cables to connect a device to the projector or to the projector body. The longer
the cable, the more susceptible to noise it becomes. Since using a cable while it is wound makes it act like an
antenna, it is more susceptible to noise.
g When connecting cables, connect GND first, then insert the connecting terminal of the connecting device in a
straight manner.
f Acquire any connection cable necessary to connect the external device to the system that is neither supplied
with the device nor available as an option.
f If video signals from video equipment contain too much jitter, the images on the screen may wobble. In this
case, a time base corrector (TBC) must be connected.
f The projector accepts video signals, Y/C signals, YC
signals are TTL level), and digital signals.
f Some computer models or graphic cards are not compatible with the projector.
f Use a cable compensator when you connect devices to the projector using long cables. Otherwise the image
may not display properly.
f Refer to "List of compatible signals" (x page 246) for the types of video signals that can be used with the
projector.
<RGB 2 IN> terminal pin assignments and signal names
Outside view
(11) (15)
(6)
(10)
(1) (5)
<HDMI IN> terminal pin assignments and signal names
Outside view
Even-numbered pins of (2) to (18)
(2) (18)
(1) (19)
Odd-numbered pins of (1) to (19)
52 - ENGLISH
Chapter 2 Getting Started — Connecting
C /YP
B R
Pin No. Signal name
(1) R/P
(2)
G/Y
(3) B/P
(4)
(5) GND
(6) GND
(7) GND
(8)
GND
Pin No. Signal name
(1)
T.M.D.S data 2+
(2) T.M.D.S data 2 shield
(3) T.M.D.S data 2-
(4) T.M.D.S data 1+
(5) T.M.D.S data 1 shield
(6) T.M.D.S data 1-
(7) T.M.D.S data 0+
(8) T.M.D.S data 0 shield
(9) T.M.D.S data 0-
(10) T.M.D.S clock+
P signals, analog RGB signals (synchronization
B R
Pin No.
(9)
R
(10)
(11)
B
― (12)
(13)
(14)
(15)
Pin No.
(11)
(12)
(13)
(14)
(15)
(16)
(17)
(18)
(19)
Signal name
―
GND
GND
DDC data
SYNC/HD
VD
DDC clock
Signal name
T.M.D.S clock shield
T.M.D.S clock-
CEC
―
SCL
SDA
DDC/CEC
GND
+5 V
Hot plug detection