Panasonic PT-RZ21К Operating Instructions Manual page 26

Lens hood mounting plate 2 <1>
(DPMH1089ZA)
Attention
f After unpacking the projector, discard the power cord cap and packaging material properly.
f Do not use the supplied power cord for devices other than this projector.
f For missing accessories, consult your dealer.
f Store small parts in an appropriate manner, and keep them away from small children.
Note
f The lens hood needs to be mounted to the projector when an interchangeable projection lens is used under the condition
that throw ratio is greater than 3.0 in the North America region. Always ask a qualified technician or your dealer to mount the
lens hood.
The throw ratio described here is a value calculated by dividing the actual projection distance by the projected image width.
The lens hood is assembled and mounted to the projector using the following supplied components.
Lens hood 1, Lens hood 2, Lens hood mounting plate 1, Lens hood mounting plate 2, Lens hood screws, Knurled head
screws
For the assembly and attachment, refer to the separate document "Mounting the lens hood". The components and document
of the lens hood may not be supplied depending on the country or region where you purchased the product.
f The type and number of the supplied power cords vary depending on the country or region where you purchased the
product.
f The model numbers of accessories are subject to change without prior notice.
26 - ENGLISH
Chapter 1 Preparation — Precautions for use
Lens hood screw <6>
(XYN4+F8FJK)
Knurled head screw <6>
(DPHD1026ZA)