Making Adjustments And Selections - Panasonic PT-RS20K Operating Instructions Manual

Chapter 3 Basic Operations — Switching on/off the projector

Making adjustments and selections

It is recommended to perform the focus adjustment after 30 minutes have elapsed with the focus test pattern
displayed. For details of the test pattern, refer to "[TEST PATTERN] menu" (x page 174). To use the active focus
optimizer function, set the [PROJECTOR SETUP] menu → [LENS] → [ACTIVE FOCUS OPTIMIZER] → [ACTIVE
FOCUS] to [ON], and then adjust the focus. (x page 145)
1) Press the <FOCUS> button to roughly adjust the focus of the projected image. (x page 71)
2) Change the setting of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on the
installation mode. (x page 36)
f Refer to "Navigating through the menu" (x page 85) for the operation of the menu screen.
3) Set [LENS TYPE].
f Confirm the setting of the lens type when using the projector for the first time after attaching the projection
lens. (x page 73)
4) Execute the lens calibration.
f Execute the lens calibration when using the projector for the first time after attaching the projection lens.
(x page 73)
5) Press the input selection button (<RGB1>, <RGB2>, <DIGITAL LINK>, <DVI-D>, <HDMI>, <SDI>, <SDI
1/2>) to select the input signal.
6) Adjust the front, back and sideway tilt of the projector with the adjustable feet. (x page 48)
7) Press the <SHIFT> button to adjust the position of the projected image.
8) If the input signal is the analog RGB signal or the DVI-D/HDMI signal, press the <AUTO SETUP>
button.
9) Press the <ZOOM> button to match the projected image size to the screen.
10) Press the <FOCUS> button again to adjust the focus.
11) Press the <ZOOM> button again to adjust the zoom and match the projected image size to the screen.
Note
f When the projector is switched on for the first time after purchase, as well as when the [PROJECTOR SETUP] menu → [INITIALIZE] →
[ALL USER DATA] is executed, the focus adjustment screen is displayed after projection starts, and then the [INITIAL SETTING] screen is
displayed. For details, refer to "When the initial setting screen is displayed" (x page 62).
68 - ENGLISH
5)
6) 8)
2) 3) 4) 1) 7) 9) 10) 11)
1) 10)
8)
5)
2) 3) 4)
7)
9) 11)