[Function Button]; [Status] - Panasonic PT-RS20K Operating Instructions Manual

1) Press as to select [REMOTE2 MODE].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[DEFAULT]
[USER]
f When [USER] is selected, proceed to Step 3).
3) Press the <ENTER> button.
4) Press as to select one from [PIN2] to [PIN8], and press qw to switch the setting.

[FUNCTION BUTTON]

Set the function of the <FUNCTION> button on the remote control.
1) Press as to select [FUNCTION BUTTON].
2) Press the <ENTER> button.
f The [FUNCTION BUTTON] screen is displayed.
3) Press as to select a function.
[DISABLE]
[P IN P]
[SUB MEMORY]
[SYSTEM SELECTOR]
[SYSTEM DAYLIGHT VIEW]
[FREEZE]
[WAVEFORM MONITOR]
[LENS MEMORY LOAD]
[LEFT/RIGHT SWAP]
[PROJECTION METHOD]
4) Press the <ENTER> button.

[STATUS]

Display the status of the projector.
1) Press as to select [STATUS].
2) Press the <ENTER> button.
f The [STATUS] screen is displayed.
3) Press qw to switch the pages.
f The page will change each time you press the button.
[PROJECTOR TYPE]
[SERIAL NUMBER]
[PROJECTOR RUNTIME]
[LIGHT RUNTIME]
[CONTINUOUS LIGHTING
TIME]
Chapter 4 Settings — [PROJECTOR SETUP] menu
Uses pin assignment of the <REMOTE 2 IN> terminal in standard setting. (x page 233)
Changes the setting of the <REMOTE 2 IN> terminal.
Disables the <FUNCTION> button.
Switches the [P IN P] setting ([OFF], [USER1], [USER2], or [USER3]). (x page 172)
Displays the sub memory list. (x page 177)
Switches the [SYSTEM SELECTOR] setting according to the input signal of the image being
projected.
f When the input signal is anything other than SDI1 input or SDI2 input
The [PICTURE] menu → [SYSTEM SELECTOR] (x page 98)
f When the input signal is SDI1 input or SDI2 input
g The [DISPLAY OPTION] menu → [SDI IN] → [SINGLE LINK SETTING] → [SDI1]/[SDI2] →
[SYSTEM SELECTOR] (x page 129)
g The [DISPLAY OPTION] menu → [SDI IN] → [DUAL LINK SETTING] → [SYSTEM SELECTOR]
(x page 129)
Switches the [SYSTEM DAYLIGHT VIEW] setting. (x page 95)
Temporarily pauses the image. (x page 136)
Displays the waveform of the input signal. (x page 137)
Loads the registered lens memory. (x page 142)
Switches the [LEFT/RIGHT SWAP] setting. (x page 113)
Switches the [PROJECTION METHOD] setting. (x page 139)
Displays the type of the projector.
Displays the serial number of the projector.
Displays the runtime of the projector.
Displays the runtime of the light source 1 and the light source 2.
Displays the elapsed time from when the light source is illuminated.
The elapsed time after the illumination of the light source can be confirmed when adjusting the focus.
The elapsed time is reset when the light source is temporarily turned off such as using the shutter
function.
ENGLISH - 167