B Setting Up Cellular Packet Data Connection On Pc; How To Install And Configure A Low Data Rate Modem Connection - Ublox EVK-U201SARA User Manual

B Setting up cellular packet data connection on PC

This section describes how to set up a packet data connection with Windows 7 operating systems (for PC) and
EVK-U2x, using the TCP/IP stack of the PC (external TCP/IP stack).
The following examples describe how to install and configure two different kinds of modem on Windows:
1 Low data rate modem, over the UART interface of the cellular module connected to the Windows PC by the
Cellular USB connector (J501 on EVB) or the Cellular RS232 connector (J500 on EVB)
2 High data rate modem, over the native USB interface of the cellular module connected to the Windows PC
by the Cellular Native USB connector (J313 on ADP)
B.1

How to install and configure a low data rate modem connection

This example describes how to install and configure a low data rate packet data connection on a PC with
Windows 7 operating system. This uses the TCP/IP stack of the PC over the UART interface of the cellular module
connected to the Windows PC by the Cellular USB connector (J501 on EVB) or the Cellular RS232 connector
(J500 on EVB).
1. Follow the board setup instructions in section 1.8 to provide the required connections with EVK-U2x.
2. Select "Control panel > Phones and Modem > Modems >
Add". This opens the Install New Modem Wizard.
3. Select the Don't detect my modem checkbox.
4. Select the Standard Modem (33600 b/s).
UBX-14001743 - R05
SARA-U2 series EVK - User Guide
Page 12 of 21
Appendix