B Setting Up Cellular Packet Data Connection On Pc - Ublox EVK-L4 User Manual

B Setting up cellular packet data connection on PC

This section describes how to set up a packet data connection with the Windows 7 operating systems (for PCs)
and EVK-L4, using the TCP/IP stack of the PC (external TCP/IP stack).
The following example describes how to configure the Windows PC to use the module as a high data rate
mobile router, over the native USB interface of the cellular module connected by the Cellular Native USB
connector on the ADP.
1. Open the "Network and Sharing Center" and click
on the "Local Area Connection" associated with
the NCM interface.
2. Click on the "Properties" button.
UBX-17013792 - R01
Figure 6: Network and Sharing Center
Figure 7: Local area connection status
EVK-L4 - User Guide
Appendix
Page 18 of 23