Table of Contents
Advertisement
4
Setting up cellular packet data connection
on Windows
This section describes how to set up a packet data connection on Windows 10 using the operating
system's TCP/IP stack and EVK-R8. This is also referred to as a dial-up connection.
The following examples describe how to install and configure two different kinds of modems on
Windows:
1. Low data rate modem: via the UART interface of the cellular module connected to the Windows
PC by the Cellular USB connector (J501 on EVB) or the Cellular RS232 connector (J500 on EVB)
2. High data rate modem: via the native USB interface of the cellular module connected to the
Windows PC by the Cellular Native USB connector (J700 on the ADP-R8)
4.1 How to install and configure a low data rate modem
connection
This example describes how to install and configure a low data rate packet data connection on a PC
with Windows 10 operating system. This uses the TCP/IP stack of the PC over the UART interface of
the cellular module connected to the Windows PC by the Cellular USB connector (J501 on EVB) or the
Cellular RS232 connector (J500 on EVB).
1. From Control Panel, select Phone and
Modem > Modems > Add.
This opens the Add Hardware Wizard.
UBX-22018774 - R02
C1-Public
Setting up cellular packet data connection on Windows
EVK-R8 - User guide
Page 10 of 25
Advertisement
Table of Contents
