B Setting Up A Cellular Packet Data Connection On A Windows Pc; How To Install And Configure A Modem Data Connection Over Uart - Ublox EVK-R4 Series User Manual

B Setting up a cellular packet data connection on a
Windows PC
This section describes how to set up a packet data connection with the Windows 7 operating systems (for PC)
and EVK-R4, using the TCP/IP stack of the PC (external TCP/IP stack).
The following examples describe how to install and configure two different kinds of modem on Windows:
1. Over the UART interface of the cellular module: connect the Windows PC to the Cellular USB connector
(J501 on EVB) or the Cellular RS232 connector (J500 on the EVB)
2. Over the native USB interface of the cellular module: connect the Windows PC to the Cellular Native USB
connector (J105 on the ADP)
B.1 How to install and configure a modem data connection over UART
This example describes how to install and configure a data connection on a PC with the Windows 7 operating
system. This uses the TCP/IP stack of the PC over the UART interface of the cellular module connected to the
Windows PC by the Cellular USB connector (J501 on EVB) or the Cellular RS232 connector (J500 on the EVB).
1. Follow the board setup instructions in section 1.9 to provide the required connections with the EVK-R4.
2. Select "Control panel > Phones and
Modem > Modems > Add". This opens
the Install New Modem Wizard.
3. Select the Don't detect my modem
checkbox.
4. Select the Standard
(33,600 bit/s).
UBX-16029216 - R04
Modem
EVK-R4 - User Guide
Appendix
Page 15 of 24