Table of Contents
Advertisement
AT8901M
7. Save configuration by copying it to the flash, confirm by typing "y".
(Base Fabric) #copy system:running-config nvram:startup-config
This operation may take a few minutes.
Management interfaces will not be available during this time.
Are you sure you want to save? (y/n) y
Configuration Saved!
(Base Fabric) #
To access the CLI via Fast Ethernet management port, open a telnet connection to the config-
ured IP address, port 23.
For additional information on the system configuration, refer to documentation "AT8901/02/
04M CLI Reference Manual".
Page 2 - 6
Installation
AT8901M User Guide
Advertisement
Table of Contents
