Kero-Sun LC-54 Instruction Manual page 12

AUTOMATIC CLEANING MODE
Then, use the adjustment keys to set the minute. Press the
adjustment key ▲ to increase the minute and the key ▼ to decrease
the minute. Press extension/day/set to select the right minute.
When the heater has been burning continuously for two hours at its highest setting, the burner will
automatically start an autoclean procedure. The display will show the autocleaningcode
Use the adjustment keys to set the hour at which the heater must
ning back to . The procedure takes 5 minutes, during which the heater will burn at its lowest
shutt off.
setting, while the burner autocleans. When the burner is clean again, the heater will automatically
switch back to the highest setting again.
Press the adjusment key ▲ to increase the hour and the key ▼ to
decrease the hour.
Press extension/day/set to select the right hour.
Then, use the adjustment keys to set the minute. Press the
TURNING OFF HEATER
adjustment key ▲ to increase the minute and the key ▼ to decrease
the minute. Press extension/day/set to select the right minute.
While heater is burning, press power switch to "OFF" position. This will extinguish heater and ON/
OFF Lamp on the indicator panel will go out.
The settings for program 1 for Monday are programmed and the
display shows SET for 3 seconds. The circulation fan motor will operate further, for approximately 150 seconds to assist in cooling
down heater.
After 3 seconds choose another day or end the setting mode by
pressing timer.
NEVER: Turn heater off by disconnecting the heater plug from the main elecrical supply.
Press the "timer" key to exit the weekly timer setting mode and return
DO NOT: Restart your heater for at least ten minutes.
to the time and a day of the week display. Timer lamp turns off.
AUTOMATIC DEACTIVATION
COPYING THE SETTING FROM ONE DAY TO ANOTHER
This heater is fi tted with a safety system that ensures that it swiches off automatically after 50
hours continuous operation.
The following will then appear in the display:
by pressing the button.
Use the copy function if there are multiple days during one week which should have the same
setting times.
Make sure that the heater is not burning. Press the timer key. Use
the adjustment keys until the day of its source is displayed in the
display.
Press extension/day/set to select.
The display shows:
. If desired, you can switch the heater on again
11 12
ENGLISH
run-