Er-Apb: Safety Instruc - Maico ER GH AP Installation And Operating Instructions Manual

Surface-mounted exhaust air system for single-duct air extraction according to din 18017-3
Table of Contents

Advertisement

8 Mounting preparations
8.8 ER-APB shut-off device, ER-AP shutter
6 Housing
9.
Fixing screw for
3
tab of the metal
shut-off shutter
• ER-APB with maintenance-free fire protection
shut-off device against fire transmission.
With metal exhaust socket and metal shut-off
shutter and soldered strut with soldered strut lock-
ing device. This is approved for a PAM-GLOBAL
RML cast iron ventilation duct system or a system
with a fire-proof shaft.
Also pay attention to the safety instruc-
tions: ER-APB: Safety instructions for installation
of the fire protection shut-off device [} 16].
• ER-AP plastic shutter with plastic exhaust sock-
ets and plastic backflow preventer. This is ap-
proved for use with a ceiling barrier system or
an air extraction system without fire protection.
8.8.1 ER-APB: Safety instructions for installa-
tion of the fire protection shut-off device
It is essential to observe the permissible installa-
tion positions: Permissible installation positions
for AP and APB fans [} 10].
16
9.
Metal backflow
2
preventer
10 Exhaust socket
DN 75/DN 80
DANGER Danger to life due to fire trans-
mission if the tab of the metal backflow pre-
venter is incorrectly screwed on.
It is essential to fasten the metal backflow pre-
venter and tab to the wall/ceiling with a suitable
screw and metal dowel.
Fixing screw is to be provided by the customer.
DANGER For ER-APB connection outside
the shaft: Danger to life due to fire transmis-
sion if the metal exhaust socket is incorrectly
connected to the connection duct.
Connection according to: Preparations for the ER-
APB ceiling installation (with fire protection)
[} 11].
3 steel blind rivets are prescribed for the connec-
tion with the connection socket. These must not
impair the shutter function.
Before commissioning, ensure that the shut-off
shutter moves with ease.
NOTICE The metal shut-off device is perman-
ently closed if there is no soldered strut.
Check that the soldered strut is in the correct
place before installation.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Er gh apb0084.03530084.0352

Table of Contents