Emission Control System Warranty - Sportsman GEN3000IOF Instruction Manual

Your Warranty Rights and Obligations:
The California Air Resources Board, U.S. EPA and Buffalo Corp are pleased to explain the Emission Control
System Warranty on your 2020 model year outdoor power equipment engine.
California
In California, new spark-ignited small off-road equipment engines must be designed, built and equipped to meet the
State's stringent anti-smog standards.
Other States, U.S. Territories
In other areas of the United States, your engine must be designed, built and equipped to meet the U.S. EPA
emission standards for spark-ignited engines at or below 19 kilowatts.
All of the United States
Buffalo Corp must warrant the emission control system on your power equipment engine for the periods of time
listed below provided there has been no abuse, neglect or improper maintenance of your power equipment engine.
Where a warrantable condition exists, Buffalo Corp will repair your power equipment engine at no cost to you
including diagnosis, parts and labor.
Your emission control system may include parts such as: carburetors or fuel injection system, ignition system,
catalytic converters, fuel tanks, valves, filters, clamps, connectors, and other associated components. Also, included
may be hoses, belts, connectors, sensors, and other emission-related assemblies.
Manufacturer's Warranty Coverage:
The emission control system is warranted for two years. If any emissions-related part on your engine is defective,
the part will be repaired or replaced by Buffalo Corp.
Owner's Warranty Responsibility
As the power equipment engine owner, you are responsible for the performance of the required maintenance listed
in your owner's manual. Buffalo Corp recommends that you retain all receipts covering maintenance on your power
equipment engine, but Buffalo Corp can not deny warranty solely for the lack of receipts or for your failure to ensure
the performance of all scheduled maintenance.
As the power equipment engine owner, you should however be aware that Buffalo Corp may deny your warranty
coverage if your power equipment engine or a part has failed due to abuse, neglect, improper maintenance or
unapproved modifications.
You are responsible for presenting your power equipment engine to distribution center or service center authorized
by Buffalo Corp as soon as the problem exists. The warranty repairs should be completed in a reasonable amount
of time, not to exceed 30 days. If you have any questions regarding your warranty rights and responsibilities, you
should contact a customer service representative at 1-866-460-9436
.
DEFECTS Warranty Coverage:
Adopted by the Air Resources Board, Buffalo Corp warrants to the ultimate purchaser and each subsequent
purchaser that the small off-road engine (SORE) (1) has been designed, built and equipped so as to conform with all
applicable regulation; and (2) is free from defects in materials and workmanship that cause the failure of a warranted
part to conform with those regulations as may be applicable to the terms and conditions stated below.
(a) The warranty period begins on the date the engines is delivered to an ultimate purchaser or first placed into
service. The warranty period is two years.
(b) Subject to certain conditions and exclusions as stated below, the warranty on emissions related parts is as
follows:
(1) Any warranted part that is not scheduled for replacement as required maintenance in your Owner's Manual is
warranted for the warranty period stated above. If the part fails during the period of warranty coverage, the part will
be repaired or replace by Buffalo Corp according to Subsection (4) below. Any such part repaired or replaced
under warranty will be warranted for the remainder of the period.
(2) Any warranty part that is scheduled only for regular inspection in your Owner's Manual is warranted for warranty
period stated above. Any such part repaired or replaced under warranty will be warranted for the remaining warranty
period.
ITEM # GEN3000IOF Portable Gas Fuel Inverter Generator

EMISSION CONTROL SYSTEM WARRANTY

or email info@buffalotools.com
38