Toshiba TS3000 Series Instruction Manual page 29

series Robot Controller
The input or output signal status is "1" when the contact is open. It is "0" when the
contact is closed. A total of twenty (20) signals, separated by every five (5) signals,
are displayed on the same line with the leading signal number shown on the left end.
Page 1 (Field bus input)
Ｉ／Ｏ Ｍｏｎｉｔｏｒ
ＤＩＮ３０＊
３２＊
３４＊
３６＊
Page 2 (Field bus input)
Ｉ／Ｏ Ｍｏｎｉｔｏｒ
ＤＩＮ４０＊
４ ２＊
４ ４＊
４ ６＊
Press DOUT to call the output screen.
Press the NEXT key or the "ALT + ↓" keys three (3) times to call the page where the
outputs from the field bus are displayed.
Now, you can make sure that the one-hundred-twenty-eight (128) field bus output
signals can be turned on and off.
The operative keys and contents of operation are listed below.
Key
←
Used to move the cursor to the left. When the cursor is located
at the left end, it will not move any further.
→
Used to move the cursor to the right. When the cursor is located
at the right end, it will not move any further.
↑
Used to move up the cursor. When the cursor is located at the
top, it will not move any further.
↓
Used to move down the cursor. When the cursor is located at
the bottom, it will not move any further.
ALT + ↓
Used to call the next page. When the final page is displayed, the
page will not change over.
FIELD BUS SLAVE FUNCTION MANUAL
（Ｆｉｅｌｄｂｕｓ１
１ １０
０００００ ０００００
０００００ ０００００
０００００ ０００００
００００
ＤＩＮ
（Ｆｉｅｌｄｂｕｓ２
１ １０
０００００ ０００００
０００００ ０００００
０００００ ０００００
００００
ＤＩＮ
- 28 -
ＩＮ）
１１
０００００ ０００００
０００００ ０００００
０００００ ０００００
ＤＯＵＴ ＳＹＳ
ＩＮ）
１１
０００００ ０００００
０００００ ０００００
０００００ ０００００
ＤＯＵＴ ＳＹＳ
Descriptions
４／５
２０
５／５
２０
STE 80756