Cobalt Digital Inc 3G Fusion 9931-EMDE Product Manual page 84

3
Table 3-2 9931-EMDE Function Menu List — continued
Note: •
Default factory preset routing routes embedded Ch 1 thru Ch 16 to bus channels Bus Ch 1 thru Bus Ch 16.
•
Bus Ch 2 thru Bus Ch 16 have controls identical to the controls described here for Bus Ch 1. Therefore, only the
Bus Ch 1 controls are shown here.
•
For each bus channel, its source should be considered and appropriately set. Unused bus channels should be set to
the Silence selection.
• Bus Channel Source
• Embedded Ch 1 thru Ch 16 as Source
• AES Ch 1 thru AES Ch 16 as Source
• Analog Ch 1 thru Ch 8 as Source
3-32
• •
•
• •
•
• •
•
9931-EMDE PRODUCT MANUAL
9931-EMDE Function Menu List and Descriptions
(continued)
Using the Source drop-down list, selects the audio input source to be
directed to the corresponding bus channel from the choices described
below.
Embed Ch 1 thru Embed Ch 16 range in Source drop-down list routes an
embedded channel (Ch 1 thru Ch 16) to be the source for the selected
destination bus channel.
(In this example, Embed Ch 1 (embedded Ch 1) is the source for
destination Bus Ch 1)
AES Ch 1 thru AES Ch 16 range in Source drop-down list routes an AES
channel (Ch 1 thru Ch 16) to be the source for the selected destination
bus channel.
(In this example, AES Ch 1 is the source for destination Bus Ch 1)
Note: • AES inputs are only available on card equipped with option
+AES (AES audio I/O).
• AES port connectors (channel pairs) on the card rear module
are set as either Input or Output using the AES Port Direction
control on the Output Audio Routing/Controls DashBoard tab.
Make certain an AES channel pair is not being used an output
before assigning it as a source here. (Refer to Output Audio
Routing/Controls (p. 3-41) for more information.)
Analog Ch 1 thru Analog Ch 8 range in Source drop-down list routes an
analog channel (Ch 1 thru Ch 8) to be the source for the selected
destination bus channel.
(In this example, Analog Ch 1 is the source for destination Bus Ch 1)
Note: • Analog audio inputs are only available on card equipped with
option +ANAIO, +ANAVI, or +ANAVO (analog audio I/O).
• Analog audio connectors on the card rear module are set as
either Input or Output using the AN-AUD I/O (1-8) Mode
Switches, located on the 9931 analog audio piggyback PCB.
Make certain an analog channel is not being used an output
before assigning it as a source here. (Refer to Setting I/O
Switches for Analog Audio (1-8) Ports (p. 2-1) for more
information.)
9931-EMDE-OM (V1.17)