LeCroy LW110 User Manual page 206

Trigger Start Phase
Prog rammable Units
Range
Resoluti on
B akpoint re
Range
Event to cause stop at breakpoint
Event to cause
Breakpoint Erro
S r ta t/S top Con
Desc ription
Start/Stop control
System D elay
Trigger to waveform output
S TAND ARD WAV EFORMS
Frequency R ange
Source Internal synthesizer
Sin e
Frequency Range
Band Flatne
Programmable P
Tria ngle
Frequency Range:
Adjustable Parameters
Square
Frequency R ange
Adjustable Parameters
Pul se/Ramp
Frequency Range
Adjustable Pa rameters
Delay
Rise Time
High Time
Fall Ti me
Sinc (Sine(x)/x)
Frequency Range
Adjustable Parameters
Cycles
Specifications A-4
start from breakpoint
r
trol
ss
arameters
Waveform starts from point n and completes at point n-1.
Waveform points
0 to 999999 waveform points
4 points
Waveform starts afte r trigger and stops at breakpoint
position. Each channel can be pro
breakpoints
0 to 999999 waveform points
SCPI command or valid stop signal at the TRIG input.
SCPI command or valid start signal at the TRIG input.
±4 points
Valid signal at the Trigger input stops th
programmed breakpoin
simultaneously on both
separately and independently at a breakpoint uniquely
programmed for each channel. If breakpoint has not been
programmed, the waveform will stop after the last point.
Rear Panel Trigger Input BNC, RS232 or GPIB commands
1 Sample Clock+150 ns
Wavef orm dependent
100 µHz to 50 MHz
5% to 10 MHz; 20%, to 50 MHz
Start phase, 0 to 360°
100 µHz to 12.5 MHz, usable above 12.5 MHz
Start phase, 0 to 360°
100 µHz to 50 MHz
Duty cycle, 1% to 99%
10 mHz to 12.5 MH z, usable above 12.5 MHz
0% to 99.9% of period
0% to 9 9.9% of period
0% to 99.9% of period
0% to 99.9% of period
10 mHz to 12.5 MHz, usa
4 to 100 cycles
User Manual LW120
grammed with its unique
e waveform at a
t. The Stop sign al operates
channels. Channel stop occurs
ble above 12.5 MHz