Table of Contents
Advertisement
User Manual LW120
Figure 5-60. The Waveform Screen
Notice on the left top and on the right top there are two triangles
pointing to the center of the screen. These are the anchors. The
anchor
s are used as the start and end pointers where your waveform
will
be created. For example, if you want to create a sine waveform
between point 100 and point 500, you place the left anchor at point
100 and the r
ight at point 500 and then generate the sine from the
built-in library.
There are two ways to control anchor placements.
1)
Click and hold your mouse cursor on the left anchor triangle and
then drag the curtain to the left position. Do the same for the right
anchor. Notice the X and Y coordinates at the top of the waveform
screen and how t
placement.
2) You can also place your anchors in a more precise manner from
the waveform library by programming the start and end points for
the waveform. An example of anchor placement using the sine
dialog box is shown in Figure 5-14.
Finally, when you are done creating and editing your waveform, you
can save your work to a directory of your choice. The name at the title
hey change to correspond to your anchor
ArbExplorer 5-37
Advertisement
Table of Contents
