Quectel BG96 Developer's Manual page 70

Section Parameter
nvqueuetrace
teletrace
update_autoreboot
[network]
apn
apnpass
apnuser
band
63
Definition
The default size is intended for devices sending small
message payloads. Increase this amount if you are using
devices that send large message payloads.
For large messages, you must ensure that the maximum NV store
size is at least four times the largest expected published message
size, plus eight bytes for the storage header. For example, for 1000
byte messages, set a minimum nvqueuemaxsize of 4032.
Non-volatile (NV) queueing subsystem trace level (0-4), for
Support purposes. Leave as
Data connection subsystem trace level (0-4), for Support purposes.
Leave as (default).
1
ETM will automatically reboot after an OTA update is processed,
either:
– automatic reboot disabled
0
If you disable this parameter, the
+ETM:REBOOT REQUIRED
update, requiring the host to tell ETM when to reboot. To
apply the changes, the host must reset ETM as soon as
possible by sending
responds with
ERROR: busy
shortly.
(default) – automatic reboot enabled
1
If you enable this parameter, ETM will automatically
reboot after an update and issue the
+ETM:REBOOTING
the
+ETM:IDLE
telemetry mode.
Network parameters
Access Point Name
APN password
APN user name
Comma-separated list of frequency bands, for example:
0xf,0x400a0e189f,0xa0e189f
Eseye-enabled Quectel BG96 module Developer Guide v1.8
Using the Quectel BG96 module configuration file
(default).
1
URC will appear after an
AT+ETMSTATE=reboot
the host should try again
URC. After this, the host must wait for
URC before starting the desired
. If ETM