Quectel BG96 Developer's Manual page 25

Installing AnyNet IRIS
6. Select Next to deploy the stack to the selected region.
The initial stack enables Eseye cross-account access to your customer account.
indicates the deployment has completed successfully.
indicates the deployment has failed, which may occur because AWS is not ready. Try again.
If required, select the supplied link on the Foundation Stack page to view the full log files. If you
cannot progress, contact Support: cloudconnect@eseye.com.
7. Select Continue.
8. On the Email Notifications page, type the email addresses where you want to send AnyNet IRIS
advisory and alert notifications, then select Next.
AnyNet IRIS emails each supplied email address with a verification link.
9. Open each email, then select the Confirm subscription link to verify that email address.
The AWS Subscription confirmed page appears for each subscription. The AnyNet IRIS Email
Notifications page updates.
indicates successful subscription.
indicates the subscription has failed. If you cannot progress, contact Support:
cloudconnect@eseye.com.
10. Using AnyNet IRIS, select Continue.
11. On the Service Region page, select the AWS IoT regions where you want to deploy AnyNet IRIS
resources.
12. Select Complete to deploy the resource stack to the selected regions.
This may take a few minutes to complete.
13. Select Review to view Configuration, Status and Updates information.
For information about using AnyNet IRIS, including viewing and setting parameters, see
Reviewing thing
Continue configuring your system to send and receive data.
Eseye-enabled Quectel BG96 module Developer Guide v1.8
connectivity.
18