Introduction; Intended Use; General Warnings And Cautions - Linvatec 3CCD Instruction Manual

1.0

INTRODUCTION

t is recommended that personnel study this
I
manual before attempting to operate, clean,
and/or sterilize the Linvatec 3CCD Digital
Camera System (IM3300, IM3301) and acces-
sories. The safe and effective use of this equip-
ment requires the understanding of and
compliance with all warnings, cautionary
notices, and instructions marked on the product,
and included in this manual.
1.1

Intended Use

The Linvatec 3CCD Digital Camera System is
intended to provide video capabilities in a vari-
ety of endoscopic surgical procedures, including
but not limited to, orthopedic, laparoscopic, uro-
logic, sinuscopic, plastic and as an accessory for
microscopic surgery.
1.2

General Warnings and Cautions

1. This equipment is designed for use by med-
ical professionals completely familiar with
the required techniques and instructions for
use of the equipment. Read and follow all
warning and cautionary notices and
instructions marked on the product and
included in this manual .
2. Do not attempt to open or service
controller chassis while under
warranty, as this may void your
warranty. There are no user-serviceable
parts inside. Removing the cover may intro-
duce an electric shock hazard by exposing
you to dangerous high voltages or other
risks. If the system malfunctions, return it
for service immediately.
3. Do not use camera with incompatible
equipment or accessories that are not autho-
rized by Linvatec. Doing so may void certi-
fications and/or warranties.
4. Prior to each use, the controller and all
associated equipment must be inspected for
proper operation. Visually inspect lenses to
assure there are no scratches, chips or
cracks.
5. Do not expose controller to moisture, oper-
ate in wet areas, or place liquids on or
above controller.
6. Do not excessively bend or kink the instru-
ment power cord.
7. The scope tip can get extremely hot as a
result of high intensity light and can
cause severe burns.
8. Handle all equipment carefully. If controller
or camera head is dropped or damaged in
any way, return it immediately for service.
9. If the camera head is damaged in any way,
or cable or connector jacket are cut, do not
autoclave camera head, or immerse camera
head in liquid (water, chemical disinfectants
or sterilants, etc.). Notify your Linvatec
Sales Representative.
10. Store camera head and all accessories in a
protective container to prevent damage dur-
ing storage. Do not store controller where it
will be exposed to temperatures in excess of
122 ° F (+ 50°C).
11. Do not use in presence of flammable anes-
thetics, gases, disinfecting agents, cleaning
solutions, or any material susceptible to
ignition due to electrical sparking.
1