Memory Upgrade Module - Fujitsu 735Dx User Manual

S e c t i o n F o u r
Figure 4-11 Opening the Memory Upgrade Compartment
Figure 4-12 Removing a Memory Upgrade Module
108

MEMORY UPGRADE MODULE

Your notebook has 16MB or 32MB of installed
SDRAM. To increase your memory capacity
you may install a memory upgrade module in
the memory upgrade compartment in the bot-
tom of your notebook. The memory upgrade
module is a dual-in-line memory module
(DIMM). You may add modules of different
capacity. SDRAM modules are recommended
but EDO modules will work. Installing an EDO
module will cause your system to operate at a
slower rate.
C A U T I O N
Never remove screws except the ones
specifically shown in the directions for
installing and removing the memory
upgrade module.
To Install a Memory Upgrade Module:
1. Turn off power to your notebook using the
power switch, (see Power Off on pages 24-25),
and remove any power adapter (AC or
auto/airline).
2. Make sure that all the connector covers
are closed.
3. Turn the notebook bottom side up, with the
front panel toward you.
4. Remove the screws at the front of the
memory upgrade module compartment.
(See Figure 4-11)
5. Remove the cover by tilting the front edge up
and then pulling forward until the tabs on
the cover are free. (See Figure 4-11.)
6. Remove the memory upgrade module from
the static guarded sleeve.