Volume Control; Floppy Disk Drive - Fujitsu 735Dx User Manual

S e c t i o n T w o

VOLUME CONTROL

All system and application functions have mul-
tiple volume controls which interact with each
other. There is the hardware volume control on
the right side panel o f your notebook. There is
a volume control in the ESS AudioRack, your
operating system Sound Control panel and any
other application with sound.
Each setting source puts an upper limit on the
volume which can be set by the other sources.
For example if the hardware volume control is
turned all the way down, your software volume
control settings have no effect. By the same
token, if the ESS AudioRack has the sound
turned off, adjusting the hardware or other
application software volume settings will not
produce sound.One easy operating method is
to use the hardware and ESS AudioRack volume
controls to set an upper limit on sound le vel
and then make fine adjustments with othe r
application software.
34
C A U T I O N
The ESS AudioRack volume setting sets
the maximum volume level of the hard-
ware volume control knob.
C A U T I O N
If you use a speakerphone function,
be sure that the microphone setting in
the ESS AudioRack (recorder portion)
is disabled.

FLOPPY DISK DRIVE

The modular floppy disk drive is a 3.5"drive
which can read and write on 1.44MB and
720KB memory capacity floppy disks. Floppy
disk format is controlled from your operating
system. (See your software documentation for
more information.) The modular floppy disk
drive can be used in Multi-function Bay 1,
Multi-function Bay 2 with the device adapter
for Multi-function Bay 2, or you can use the
optional external floppy disk drive. The system
will treat any floppy disk drive in exactly the
same way regardless of where it is installed.
(For floppy disk drive installation and removal
instructions see Multi-function Bays on pages 97-
100 and External Installation of a Floppy Disk
Drive on page 107.) When your system boots it
will always look first for a floppy disk drive in a
Multi-function Bay 1, Multi-function Bay 2, and
then look at the external floppy disk drive port.
C A U T I O N
To get your system to recognize a newly
installed floppy disk drive you must
restart your notebook.
Loading a Floppy Disk
To load,insert a floppy disk into the floppy disk
drive,shutter side first and label up, until the
Eject button,above the floppy disk drive open-
ing, pops out. (Figure 2-10)