Fujitsu 735Dx User Manual page 129

Problem
The CD-ROM Access indicator on the Status
Indicator panel blinks at regular intervals when
no CD is in the tray or the CD-ROM drive is
not installed.
Docking Problems
Notebook does not turn on when installed in
Docking Station.
T r o u b l e s h o o t i n g
Possible Cause
5. Setup utility is set to something other than
CD-ROM for the Secondary Master Controller.
6. Wrong drive designator was used for
CD-ROM in the application
7. Windows CD auto insertion function
is disabled.
1. The Windows CD auto insertion function
is active and is checking to see if a CD is
ready to run.
1. LANdock AC adapter is not
plugged in.
L i f e B o o k 7 0 0 S e r i e s f r o m F u j i t s u
Possible Solution
5. Revise BIOS settings to set IDE Adapter
1 Master correctly. (See Main menu and
IDE Adapter submenu pages 56-62 for
more information.)
6. Verify the drive designator used by the
application is the same as the one used by
the operating system. When the operating
system is booted from a CD-ROM drive
designations are automatically adjusted.
(See Boot Options submenu on pages 63-64.)
7. Start the CD from the desktop or
application software or re-enable the
Windows CD auto insertion function.
(See CD-ROM Access Indicator on pages
21-22 for more nformation.)
1. This is normal.
You can disable this function if you wish.
(See CD-ROM Access Indicator on pages
21-22 for more information. )
1. Provide power to the LAN-Docking
Station.
121