To Remove A Memory Upgrade Module - Fujitsu LifeBook N series User Manual

7. Replace the cover. (Figure 5-4)
8. Replace the screws.
The memor y upgrade module is not
something you routinely remove from your
notebook. Once it is installed, you should
leave it in place unless you want to change
system memory capacity.
To Remove a Memory Upgrade
Module
1. Perform steps 1 through 4 of Installing a
Memory Upgrade Module.
2. Pull the clips sideways away from each side
of the memory upgrade module at the same
time.
3. While holding the clips out, remove the
module from the slot by lifting it up and pulling
towards the rear of your notebook.
4. Store the memory upgrade module in a static
guarded sleeve.
5. Replace the cover.
Checking the Computer Recognition
of New Memory Capacity
Once you have changed the system memory
capacity by either adding or removing a memory
upgrade module, be sure to check that your
LifeBook notebook has recognized the change.
You can check the memory capacity by looking
at the Info menu of the BIOS setup:
1. Turn on the power to your LifeBook notebook
using the Power/Suspend/Resume button.
52
2. Allow the system to start booting and press
the F2 key once the Fujitsu logo appears on
the screen with a prompt below it. This will
open the main menu of the BIOS setup with
the current settings displayed. Use the right
arrow key to select Info in the BIOS Setup
menu.
If the total memory displayed is incorrect,
check that your memory upgrade module is
properly installed.