Fujitsu 735Dx User Manual page 118

C A U T I O N
The memory upgrade module can be
severely damaged by electro-static dis-
charge (ESD). Be sure you are properly
grounded when handling and installing
the module.
7. Align the connector edge of the memory
upgrade module with the connector slot in
the compartment. The notch on the module
should be on the right with the part side up
and the connector pointing toward the front
of the notebook and aligned with the notch
in the connector inside the compartment.
(Figure 4-12.)
8. Insert the memory upgrade module at a 45°
angle. (Figure 4-12.) Press the connector edge
of the module firmly down and into the con-
nector.
9. Press the memory upgrade module down
into the compartment until it lodges under
U s e r I n s t a l l a b l e
the retaining clip. You will hear a click when
it is properly in place.
10. Replace the cover by hooking the tabs under
the rear edge of the compartment opening
and tilting down until flush with the bot-
tom of your notebook.
11. Replace the screws.
The memory upgrade module is not something
you routinely remove from your notebook.
Once it is installed, you can leave it in place
unless you want to increase system
memory capacity.
C A U T I O N
Before you install or remove the memory
upgrade module, save changes and close
all files and turn power off to your note-
book. (See Power Off on pages 24-25.)
L i f e B o o k 7 0 0 S e r i e s f r o m F u j i t s u
F e a t u r e s
To Remove a Memory Upgrade Module:
1. Perform steps 1 through 5 of To Install a
Memory Upgrade Module.
2. Pull the clips sideways away from each side of
the memory upgrade module at the same
time. (Figure 4-12).
3. While holding the clips out, remove the mod-
ule from the slot by lifting it up and pulling
towards the rear edge of your notebook.
(Figure 4-12).
4.Store the memory upgrade module in a static
guarded sleeve.
5. Replace the cover by following the instructions
in steps 10 and 11 of the instructions for To
Install a Memory Upgrade Module, or install
a new memory upgrade module and then
replace the cover by following the instructions
in steps 7 through 11 of the instructions
To Install a Memory Upgrade Module.
109