KNOVA KN M-2509RC Manual page 12

ASSEMBLY
5
9. Remove the arbor bolt (4), the outer blade collar (6),
and the blade (7). Do not remove the inner blade collar.
(Fig. J)
10. Raise the lower blade guard (1) to the upright position to
remove the blade. (Fig. H-1)
NOTE: Pay attention to the pieces removed, noting their
position and direction they face. Wipe the blade collars
clean of any sawdust before installing a new blade.
7
6
4
Installing the Blade (Fig. H, H-1, I, J)
1. Install a 10 in. blade with a 5/8 in. arbor hole making sure
the rotation arrow on the blade matches the clockwise
rotation arrow on the upper guard, and the blade teeth
are pointing downward at the front of the saw.
2. Place the outer blade collar (6) against the blade and on
the arbor. Thread the arbor bolt (4) onto the arbor in a
anti-clockwise direction. (Fig. J)
IMPORTANT: The flat side of the blade collar must be
placed against the blade. Do not install the collar with
the curved side against the blade.
3. Place the blade wrench on the arbor bolt (4).
4. Press the arbor lock button (5), holding it in firmly while
turning the blade wrench anti-clockwise. Continue to
press it in while tightening the arbor bolt securely. (Fig. I)
5. Rotate the cover plate (3) and lower blade guard (1) back
to its original position. (Fig. H-1)
6. Lower the blade guard and replace the cover plate screw
(2) and tighten with a Phillips screwdriver. (Fig H)
7. Pull the main handle down and up several times to confirm
the lower blade guard operates without binding.
8. Be sure the arbor lock button (5) is released so the blade
turns freely.
WARNING
without the cover plate secure in place. It keeps the
arbor bolt from falling out if it accidentally loosens,
and helps prevent the spinning blade from coming
off the saw.
• Make sure the collars are clean and properly arranged.
Fig. I
Lower the blade into the table and check for any
contact with the metal base or the saw table.
REMOVING AND INSTALLING THE TABLE INSERT (FIG. K)
WARNING
• Always unplug the saw to avoid accidental
starting. Remove all small pieces of material from
the table cavity before performing any cuts.
The table insert may be removed for this purpose,
but always reattach the table insert prior to
performing a cutting operation.
• Do not start the sliding compound miter saw without
checking for interference between the blade and
table insert. Damage could result to the blade, table
insert or turntable if blade strike occurs during
the cutting operation.
1. To remove, loosen and remove the six screws (1) on the
table insert (2) with a Phillips screwdriver and remove
the insert.
2. To install, reposition the table insert, install the six screws
and tighten.
3. Check for blade clearance by moving the slide carriage
through the full motion of the blade in the table slot.
Fig. J
11
• To avoid injury, never use the saw
To avoid injury:
1
2
Fig. K