Table of Contents
Advertisement
a. Enter the Extended Services Set Identification (ESSID) and name associated with the
WLAN. For additional information on creating and editing up to 16 WLANs per access
point, see
b. Use the
Available On
the 802.11a or 802.11b/g radio. Ensure the radio selected has been enabled (see step 8).
c. Even an access point configured with minimal values must protect its data against theft
and corruption. A security policy should be configured for WLAN1 as part of the basic
configuration outlined in this guide. A security policy can be configured for the WLAN
from within the
used as needed as security requirements change. Symbol recommends you familiarize
yourself with the security options available on the access point before defining a
security policy. Refer to
10. Click
Apply
to save any changes to the access point Quick Setup screen. Navigating away
from the screen without clicking Apply results in all changes to the screens being lost.
11. Click
Undo Changes
settings displayed on the access point Quick Setup screen to the last saved configuration.
3.3.1.1 Configuring WLAN Security Settings
To configure a basic security policy for a WLAN:
1. From the access point Quick Setup screen, click the
Policy item.
The
New Security Policy
authentication
is) would provide no security and might only make sense in a guest network wherein no
sensitive data is either transmitted or received. Consequently, at a minimum, a basic
security scheme (in this case WEP 128) is recommended in a network environment wherein
sensitive data is transmitted.
NOTE For information on configuring the other encryption and authentication
2. Ensure the
Name
of the policy.
Creating/Editing Individual WLANs on page
checkboxes to define whether the target WLAN is operating over
Quick Setup
screen. Policies can be defined over time and saved to be
Configuring WLAN Security Settings on page
(if necessary) to undo any changes made. Undo Changes reverts the
screen displays with the
and
No Encryption
options selected. Naming and saving such a policy (as
options available to the access point, see
page
6-2.
of the security policy entered suits the intended configuration or function
5-24.
3-9.
Create
button to the right of the Security
Manually Pre-shared key/No
Configuring Security Options on
3-9
Getting Started
Advertisement
Table of Contents
