Voice Prioritization; Support For Cam And Psp Mus; Statistical Displays - Symbol AP-51 Series Product Reference Manual

1-17
Introduction
communication. Therefore, if an MU's WLAN is configured for MU-MU disallow, it will not be able to
communicate with any other MUs connected to this access point.
For detailed information on configuring an access point WLAN to disallow MU to MU
communications, see Creating/Editing Individual WLANs on page 5-24.

1.2.15 Voice Prioritization

Each access point WLAN has the capability of having its QoS policy configured to prioritize the
network traffic requirements for associated MUs. A WLAN QoS page is available for each enabled
WLAN on either the access point 802.11a or 802.11b/g radio.
Use the QoS page to enable voice prioritization for devices to receive the transmission priority they
may not normally receive over other data traffic. Voice prioritization allows the access point to assign
priority to voice traffic over data traffic, and (if necessary) assign legacy voice supported devices (non
WMM supported voice devices) additional priority.
For detailed information on configuring voice prioritization over other voice enabled devices, see
Setting the WLAN Quality of Service (QoS) Policy on page 5-33.

1.2.16 Support for CAM and PSP MUs

The access point supports both CAM and PSP powered MUs. CAM (Continuously Aware Mode) MUs
leave their radios on continuously to hear every beacon and message transmitted. These systems
operate without any adjustments by the access point.
A beacon is a uniframe system packet broadcast by the AP to keep the network synchronized. A
beacon includes the ESSID, access point MAC address, Broadcast destination addresses, a time
stamp, a DTIM (Delivery Traffic Indication Message) and the TIM (Traffic Indication Map).
PSP (Power Save Polling) MUs power off their radios for short periods. When a Symbol MU in PSP
mode associates with an access point, it notifies the access point of its activity status. The access
point responds by buffering packets received for the MU. PSP mode is used to extend an MU's battery
life by enabling the MU to "sleep" during periods of inactivity.

1.2.17 Statistical Displays

The access point can display robust transmit and receive statistics for the WAN and LAN ports.
WLAN stats can be displayed collectively and individually for enabled WLANs. Transmit and receive
statistics are available for the access point's 802.11a and 802.11b/g radios. An advanced radio
statistics page is also available to display retry histograms for specific data packet retry information.