Configuring Data Access - Symbol AP-51 Series Product Reference Manual

NOTE The
6. Click Undo Changes
settings displayed on the System Settings screen to the last saved configuration.
7. Click Logout to securely exit the access point Symbol Access Point applet. A prompt
displays confirming the logout before the applet is closed.

4.2 Configuring Data Access

Use the access point Access
LAN2 and/or WAN interfaces and display screens for changing administrator passwords.
Use the access point Access screen checkboxes to enable or disable LAN1, LAN2 and/or WAN access
using the protocols and ports listed. If access is disabled, this effectively locks out the administrator
from configuring the access point using that interface. To avoid jeopardizing the network data
managed by the access point, Symbol recommends enabling only those interfaces used in the routine
(daily) management of the network, and disabling all other interfaces until they are required.
To configure access for the access point:
1. Select System Configuration
Apply button is not needed for restoring the access point default
configuration or restarting the access point.
(if necessary) to undo any changes made. Undo Changes reverts the
screen to enable/disable data throughput to the access point's LAN1,
-> access point Access
System Configuration
from the access point menu tree.
4-5