Configuring The Protonode; Retrieve The Sample Configuration File; Change The Configuration File To Meet The Application; Figure 19: Fs-Gui File Transfer - MSA fieldserver ProtoNode FPC-N54 Startup Manual

Configuring the ProtoNode

8
8.1

Retrieve the Sample Configuration File

The configuration of the ProtoNode is provided to the ProtoNode's operating system via a comma-delimited
file called "CONFIG.CSV".
If a custom configuration was ordered, the ProtoNode will be programmed with the relevant device registers
in the Config.csv file for the initial start-up. If not, the product is shipped with a sample config.csv that shows
an example of the drivers ordered.
•
In the main menu of the FS-GUI screen, go to "Setup", then "File Transfer", and finally "Retrieve".
•
Click on "config.csv", and open or save the file.
8.2

Change the Configuration File to Meet the Application

Refer to the FieldServer Configuration Manual in conjunction with the Driver supplements for information
on configuring the ProtoNode.

Figure 19: FS-GUI File Transfer

ProtoNode Start-up Guide
Configuring the Gateway
21