Table of Contents
Advertisement
6.0
INSTALLATION NOTES AND ASSEMBLY INSTRUCTIONS
NOTE: Be sure to avoid touching the circuit boards with metal objects, as this
may cause damage.
6.1
Using a 301-037 security tool (sold separately), loosen and remove the
security screw.
6.2
Separate the cover assembly from the backplate assembly by pulling the
bottom forward and pushing up.
6.3
The backplate assembly may be installed on any standard backboard or
suitable vertical surface. Four mounting holes are provided.
6.4
Run the inside station wire through the backplate assembly and terminate
on to the RJ11C terminal block on the backplate.
6.5
The use of a gas tube station protector is recommended. The station
ground should not exceed 50 ohms.
6.6
Plug the modular line cord from the cover assembly into the RJ11C
terminal block.
6.7
Dress the line cable away from the security screw and install the cover
assembly by inserting the tabs into the slots on top of the backplate.
6.8
Secure the cover assembly by tightening the security screw.
A.
Never install telephone wiring during a lightning storm.
B.
Never install telephone jacks in wet locations unless the jack
is specifically designed for wet locations.
C.
Never touch uninsulated telephone wires or terminals unless
the telephone line has been disconnected at the network
interface.
D.
Use caution when installing or modifying telephone lines.
*****WARNING*****
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
ISSUE 4.0
12
Advertisement
Table of Contents
