Table of Contents
Advertisement
4.0
TESTING/OPERATION
4.1
With the phone connected to the DTMF test set or working telephone line,
lift the handset. Any number that was programmed into Location #19
should automatically dial out, at this time. If not, hang up the phone and
repeat sections 3.2, 3.3, 3.6 and 3.10 only. If this does not solve the
problem, please refer to section 7.0.
4.2
If any number was programmed into Location #18, that number should
automatically dial out approximately one second after the number stored
in Location #19 dials out. If not, hang up the phone and repeat sections
3.2, 3.3, 3.7 and 3.10 only. If this does not solve the problem, please refer
to section 7.0. Please note that, in order to use Location #18, Location #19
must first be used.
4.3
If Locations #19 and/or #18 have not been programmed, you should
receive dial tone on the line.
4.4
If you programmed speed-dial numbers into it, try them now. When you
press the # key followed by the two-digit location code, any number stored
in that location should be released. For example, entering #30 should
cause the phone to automatically dial any number stored in Location #30.
If not, hang up the phone and repeat sections 3.2, 3.3, 3.8, and 3.10 only.
It is not necessary to try to reprogram all of the speed dial locations, but
only the ones that are not working. If this does not solve the problem,
please refer to section 7.0.
4.5
If you opted to use phone implemented call restrictions, try some of them
now. The phone should only permit "allowed" calls to be dialed. When
you try to dial a number that you did not "allow", the phone should sound
an error tone (three short beeps) and reset the line. If not, hang up and
repeat sections 3.2, 3.3, 3.5, 3.9, and 3.10 only. If this does not solve the
problem, please refer to section 7.0.
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
ISSUE 4.0
10
Advertisement
Table of Contents
