Table of Contents
Advertisement
Quick Links
SERVICE MANUAL
STAINLESS STEEL PANEL TELEPHONE
EQUIPPED WITH CAC6.00 FIRMWARE
Communication Equipment
& Engineering Company
FOR
MODEL SSP-363-F
SSP-363-F-650-521-CAC6.00-ISSUE4.0
Serving the Telephone Industry Since 1930
519 W South Park Street
Okeechobee, FL 34972
Voice: 863-357-0798
Fax: 863-357-0006
Advertisement
Table of Contents
Related Manuals for CEECO SSP-363-F
Summary of Contents for CEECO SSP-363-F
- Page 1 SSP-363-F-650-521-CAC6.00-ISSUE4.0 SERVICE MANUAL MODEL SSP-363-F STAINLESS STEEL PANEL TELEPHONE EQUIPPED WITH CAC6.00 FIRMWARE Serving the Telephone Industry Since 1930 Communication Equipment 519 W South Park Street & Engineering Company Okeechobee, FL 34972 Voice: 863-357-0798 Fax: 863-357-0006...
- Page 2 ISSUE 4.0 IMPORTANT INFORMATION CUSTOMER Please fill in before you continue. The following information is necessary when calling CEECO for assistance. MODEL NUMBER MODEL SSP-363-F EQUIPPED WITH CAC6.00 FIRMWARE SERIAL NUMBER DATE MANUFACTURED LOCATION INSTALLED For us to better serve you, please have this information available when calling for technical support.
-
Page 3: Table Of Contents
INSTALLATION NOTES AND ASSEMBLY INSTRUCTIONS ....12 TROUBLE SHOOTING GUIDE ................ 13 SPECIFICATIONS....................15 PARTS LIST ......................16 10.0 FCC NOTICE......................17 11.0 REPAIR AND RETURN INFORMATION............18 12.0 WARRANTY POLICY ..................19 13.0 DIAGRAM......................20 CEECO Communication Equipment & Engineering Company PROPRIETARY... -
Page 4: Introduction
ISSUE 4.0 INTRODUCTION The practices in this manual provide installation and maintenance information for the Model SSP-363-F Stainless Steel Panel Telephone, equipped with CAC6.00 software. For information not included in this manual, please call or write: CEECO Customer Service 519 W South Park Street... -
Page 5: Programming
Example: Entering #00 followed by 101003 would program the phone to have no call restrictions, no incoming call allowed, a wide dial tone detect window, a muted microphone initially, DTMF dialing, and a 3 minute automatic timed call disconnect. CEECO Communication Equipment & Engineering Company PROPRIETARY... - Page 6 4=10 min. call timeout 9=30 min.call timeout • Be sure to record your selections in the table below for future reference. Telephone Options Table: #00 __ __ __ __ __ __ 2 3 4 5 6 CEECO Communication Equipment & Engineering Company PROPRIETARY...
- Page 7 #31 is dialed, and 583-9907 when #32 is dialed. Please note that, when the phone is put into operation, the # key must be dialed preceding the two digit location number, in order to release the speed dial number. CEECO Communication Equipment & Engineering Company PROPRIETARY...
- Page 8 #48 __ __ __ __ __ __ __ __ __ __ __ #68 __ __ __ __ __ __ __ __ __ __ __ #49 __ __ __ __ __ __ __ __ __ __ __ #69 __ __ __ __ __ __ __ __ __ __ __ CEECO Communication Equipment & Engineering Company...
- Page 9 3.10 Programming is now completed. Hang up the phone and return the mini-jumpers to the “OFF” position, as depicted on the last page of this manual. The phone is now ready for Testing/Operation. CEECO Communication Equipment & Engineering Company PROPRIETARY...
-
Page 10: Testing/Operation
(three short beeps) and reset the line. If not, hang up and repeat sections 3.2, 3.3, 3.5, 3.9, and 3.10 only. If this does not solve the problem, please refer to section 7.0. CEECO Communication Equipment & Engineering Company PROPRIETARY... -
Page 11: Recommended Tools And Test Equipment
Security Tool 301-037 1/4" Nut Driver *The security tool is for a standard 5/32∀ 5/16" Nut Driver button-head screw generally used on the Volt/Ohm Meter framework of telephone booth Flat Blade Screw Driver CEECO Communication Equipment & Engineering Company PROPRIETARY... -
Page 12: Installation Notes And Assembly Instructions
Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations. Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface. Use caution when installing or modifying telephone lines. CEECO Communication Equipment & Engineering Company PROPRIETARY... -
Page 13: Trouble Shooting Guide
PROBLEM: TRANSMITTER DOES NOT TURN ON POSSIBLE CAUSE: HANDSET MCRK-2 CARD NETWORK CABLE ASSY NETWORK PROBLEM: TRANSMITTER DOES NOT TURN ON FOR INCOMING CALLS POSSIBLE CAUSE: PHONE NOT PROGRAMMED TO ALLOW INCOMING CALLS. MCRK-2 CARD CEECO Communication Equipment & Engineering Company PROPRIETARY... - Page 14 PROBLEM: LOSES MEMORY CONTENTS AFTER EXTENDED PERIODS OF NO USE. POSSIBLE CAUSE: LITHIUM BATTERY PROBLEM: PHONE CANNOT BE PROGRAMMED POSSIBLE CAUSE: MEMORY CHIP MCRK-2 CARD KEYPAD KEYPAD CABLE ASSY. PROBLEM: RINGER DOES NOT OPERATE POSSIBLE CAUSE: RINGER NETWORK CEECO Communication Equipment & Engineering Company PROPRIETARY...
-
Page 15: Specifications
DIMENSIONS: 10.12" Wide x 13.12" High x 2.75" Deep MOUNTING: Vertical surface mount MEMORY RETENTION: Lithium Battery – Long Life FCC REGISTRATION: BW88T7-13823-TE-T UL LISTED NO.: 6OF5 RINGER EQUIVALENCE: 0.8A TYPE JACK: RJ11C CEECO Communication Equipment & Engineering Company PROPRIETARY... -
Page 16: Parts List
Grommet 11020 Stainless steel panel 11025 Apparatus box 321-016 1/4"x20"x3/4" security screw 650-521 MCRK-2 Board 650-570 Network cable 705-110 Chrome keypad - alphanumeric 700-008 Keypad cable Accessories: 301-037 Security tool 705-113 Chrome keypad CEECO Communication Equipment & Engineering Company PROPRIETARY... -
Page 17: Fcc Notice
FCC registration number and ringer equivalence number. These numbers are listed in section 9.00. The FCC further requires that you notify your local telephone company when permanently disconnecting this telephone. CEECO Communication Equipment & Engineering Company PROPRIETARY... -
Page 18: Repair And Return Information
11.3 NON-WARRANTY REPAIR: CEECO will repair equipment out of warranty for a set charge plus parts. The customer must pay the shipping costs both directions. 11.4 RETURN FOR CREDIT: Material may be returned for credit only with prior approval. Material authorized for return is subject to a 20% restocking charge based on the manufacturer’s list price. -
Page 19: Warranty Policy
CEECO will repair or replace any unit during this period if found to be defective for reasons other than abuse and improper use or improper installation. -
Page 20: Diagram
OVE THE MINI JUMPERS TO THE BEFORE POSITION GOING HOOK When programming is completed, move the mini jumpers to the OFF position. NOTE: Do not leave the mini jumpers in the ON position, this will decrease battery life. CEECO Communication Equipment & Engineering Company PROPRIETARY...
Need help?
Do you have a question about the SSP-363-F and is the answer not in the manual?
Questions and answers