4-4-70 Fan IPM Overheat error
Outdoor unit display
Judgment Method
∙ IPM internal temperature more than 85°C (E455, E355)
∙ Heat sink and IPM assembly defective.
Cause of problem
∙ Defective heat sink cooling
1. Cause of problem
Did check the foreign objects between
the heat sink pin?
Is the bolt of the heat sink fully tightened?
Did check the foreign objects between
the heat sink and IPM?
Samsung Electronics
(FAN1 PCB)
(FAN2 PCB)
Power Off
Yes
Yes
Yes
Complete
No
Remove foreign objects
*Cold heat sink assembly defect occurs.
No
Tighten Bolt
Remove foreign objects and
No
apply the heat sink grease.
And then reassembly
Troubleshooting
4-113