Samsung AM032MNQDCH/AA Service Manual page 212

Troubleshooting
▶ 360 cassette
You cannot set both of the indoor unit addresses and the installation options in a batch: set both of them respectively.
Common steps for setting the addresses and options
AR-KH00E remote control (for 360 cassette only)
Entering the
mode for setting
the options
Temperature
Timer button
1. Enter the mode for setting the options:
a. Remove the batteries from the remote control.
b. While holding down the
c. Make sure that you are entered to the mode for setting the options:
2. Set the option values.
CAUTION
• The total number of available options are 24: SEG1 to SEG24.
• Because SEG1, SEG7, SEG13, and SEG19 are the page options used by the previous remote control models, the modes to
set values for these options are skipped automatically.
• Set a 2-digit value for each option pair in the following order: SEG2 and SEG3
SEG11 and SEG12 SEG14 and SEG15
4-12
button
(Temp) and (Timer) buttons simultaneously, insert the batteries into the remote control.
SEG16 and SEG17
Setting the
option values
Mode button
Wheel
NOTE
The remote control display may
vary depending on the model.
SEG4 and SEG5 SEG6 and SEG8
SEG18 and SEG20 SEG21 and SEG22
SEG9 and SEG10
SEG23 and SEG24.
Samsung Electronics