Table of Contents
Advertisement
Adjusting for Material Width and Length
Setting the M6 material width and length is simple and easy.
Loosen the width adjustment bolt
and nut and the pivot bolt and nut
(Figure 15).
Either use a measuring tape or
place a sample piece of material on
the conveyor and set width of
opening 1/4" greater than width of
material being processed.
Re-tighten the pivot bolt and nut
and adjustment bolt and nut.
To set material length;
loosen the (3) bolts and
nuts that secure the end
stop and limit switch
(Figure 15 & 15A).
Align the mark to the
appropriate material
length, and then re-
tighten the (3) nuts and
bolts (Figure 15A).
Note: There are notches
between each set of
material length numbers for
2-inch adjustment
increments.
Material flow
direction
Baker M6 DeDuster - Rev 1,
11/07;
WWW.BAKER-ONLINE.COM
15
End-stop with
limit switch
Adjustment
bolt
Pivot bolt
Figure 15
Figure 15A
Advertisement
Table of Contents
