Table of Contents
Advertisement
SET-UP
Receiving and Inspection
Upon receipt and prior to signing transport carrier's documents, conduct a walk-around
and visual inspection of your new equipment. Note any damage in writing upon the
carrier's bill of lading and contact us immediately.
Note: All new equipment is assembled and thoroughly tested prior to shipment, however
damage may occur during transit, which could cause the machine to not operate correctly
during start-up.
Unpacking
If machine was delivered via flatbed trailer or container, remove straps or chains securing
it in place.
Remove lag screws, strapping, etc. that attaches the machine to the deck.
Transport machine to the installation site.
Machine Positioning (Placement, Leveling, Alignment)
For optimum performance, designate a solid and level foundation that is covered and dry,
free of environmental elements such as rain or snow that could cause electrical or slip
hazards.
We recommend you anchor the machine to the floor with the bolts in the footpads.
Provide a minimum of 3 feet of clear workspace in front of the electrical panel.
Power and Utilities Requirements
For safe and effective operation confirm your incoming voltage and available
amperage is equal to what the machine has been wired for at the factory.
A qualified electrician should complete electrical connections and check
for correct motor directional rotation.
Ensure all wiring, electrical connections and air hoses are located in a safe position
and away from any hazardous conditions.
Proper cutter rotation should be toward infeed of machine (front).
The "pusher" air pressure should be set at 45 psi.
Efficient dust and chip removal requires a minimum of 1,500 CFM suction at the
machine dust removal chute. This is an end user/owner responsibility.
Note: Failure to provide proper vacuum or suction may result in damage to machine or
operations personnel.
Baker M6 DeDuster - Rev 1,
11/07;
WWW.BAKER-ONLINE.COM
12
Advertisement
Table of Contents
