Table of Contents
Advertisement
To Begin Processing Material
Complete a visual inspection to ensure all guards/covers are in place and secure.
Turn on electrical power via the main electrical panel.
Turn on air supply.
Twist and pull up on the ALL STOP button (Figure 18).
Push the BRUSH START button to start the de-dusting brushes spinning. Wait until the
motor starts and is running at full speed, then push the FEED START button to start the
feed conveyor and material transport chains.
Begin feeding material onto the feed conveyor.
Note: Incoming material should not be stacked higher than the height of the fence / guide.
ALL STOP
Incoming material
should not be
stacked higher
than the height of
the fence / guide
BRUSH START
Baker M6 DeDuster - Rev 1,
FEED START
Figure 18
11/07;
WWW.BAKER-ONLINE.COM
18
FEED STOP
Figure 18A
Advertisement
Table of Contents
