Replacing Brushes - Baker DeDuster M6 User Manual

Replacing Brushes

Note: Follow proper Lockout / Tagout procedures prior to cleaning or performing
maintenance on any part of the machine.

On the material entry side, remove the trantorque bushing, 2-bolt hole flange bearings,
bottom brush height adjustment plate, bolt and nut and top and bottom cover plates.
(Figure 22)

On the gearbox side, remove the top and bottom locking collars. (Figure 22A)

Slide the top brush out and remove the old brush and replace with a new brush and re-
attach the trantorque bushing.

Slide the bottom brush out and remove the old brush and replace with a new brush.

Slide the new bottom brush into place and secure it to the gearbox via the locking collar.

Slide the new top brush into place and secure it to the gearbox via the locking collar.

Replace the top and bottom cover plates followed by the 2-bolt flange bearings and the
bottom brush height adjustment plate, bolt and nuts.

Set top and bottom brush height per instructions on pages 16 & 17.
Flange bearing Flange bearing
Figure 22
Baker M6 DeDuster - Rev 1,
Trantorque bushing
Cover plates
Bottom brush
height adjustment
plate, bolt and nut
11/07; WWW.BAKER-ONLINE.COM
22
Gearbox locking collar Gearbox locking collar
Figure 22A